Midwest Ob Gyn Clinic Pc

Summary Statement of Deficiencies D5439 CALIBRATION AND CALIBRATION VERIFICATION CFR(s): 493.1255(b) (b)(1) Following the manufacturer's calibration verification instructions; (b)(2) Using the criteria verified or established by the laboratory under 493.1253(b)(3)-- (b)(2)(i) Including the number, type, and concentration of the materials, as well as acceptable limits for calibration verification; and (b)(2)(ii) Including at least a minimal (or zero) value, a mid-point value, and a maximum value near the upper limit of the range to verify the laboratory's reportable range of test results for the test system; and (b)(3) At least once every 6 months and whenever any of the following occur: (b)(3)(i) A complete change of reagents for a procedure is introduced, unless the laboratory can demonstrate that changing reagent lot numbers does not affect the range used to report patient test results, and control values are not adversely affected by reagent lot number changes. (b)(3)(ii) There is major preventive maintenance or replacement of critical parts that may influence test performance. (b)(3)(iii) Control materials reflect an unusual trend or shift, or are outside of the laboratory's acceptable limits, and other means of assessing and correcting unacceptable control values fail to identify and correct the problem. (b)(3)(iv) The laboratory's established schedule for verifying the reportable range for patient test results requires more frequent calibration verification. This STANDARD is not met as evidenced by: Based on review of calibration records, lack of calibration verification records, and interview with the technical consultant, the laboratory failed to perform calibration verification every 6 months on their chemistry instrument, Vitros 350, on analytes sodium, potassium, and chloride in 2025. 1. Laboratory records revealed starting in 2025 the laboratory began using two calibrators for sodium, potassium, and chloride calibrations. 2. Review of laboratory records revealed the laboratory did not perform calibration verification on analytes sodium, potassium, and chloride in 2025. 3. Statement of Deficiencies (X1) Provider/Supplier/CLIA Identification Number (X3) Date Survey Completed Name of Provider or Supplier Street Address, City, State -- 1 of 2 -- Interview with the technical consultant on 11/4/2025 at 11:38 AM, confirmed the laboratory failed to perform calibration verification on analytes sodium, potassium, and chloride every six months in 2025. -- 2 of 2 --

Summary Statement of Deficiencies D6063 LABORATORY TESTING PERSONNEL CFR(s): 493.1421 The laboratory must have a sufficient number of individuals who meet the qualification requirements of 493.1423, to perform the functions specified in 493. 1425 for the volume and complexity of tests performed. This CONDITION is not met as evidenced by: Based on lack of documentation the laboratory failed to have proof of education on testing personnel #3, as listed on the CMS-209, performing moderate complexity testing. Refer to D6065. D6065 TESTING PERSONNEL QUALIFICATIONS CFR(s): 493.1423(b)(1)(2)(3)(4)(i) (b) Meet one of the following requirements: (b)(1) Be a doctor of medicine or doctor of osteopathy licensed to practice medicine or osteopathy in the State in which the laboratory is located or have earned a doctoral, master's, or bachelor's degree in a chemical, physical, biological or clinical laboratory science, or medical technology from an accredited institution; or (b)(2) Have earned an associate degree in a chemical, physical or biological science or medical laboratory technology from an accredited institution; or (b)(3) Be a high school graduate or equivalent and have successfully completed an official military medical laboratory procedures course of at least 50 weeks duration and have held the military enlisted occupational specialty of Medical Laboratory Specialist (Laboratory Technician); or (b)(4)(i) Have earned a high school diploma or equivalent; and This STANDARD is not met as evidenced by: Based on lack of documentation and interview with the laboratory manager, the Statement of Deficiencies (X1) Provider/Supplier/CLIA Identification Number (X3) Date Survey Completed Name of Provider or Supplier Street Address, City, State -- 1 of 2 -- laboratory failed to have proof of education on one out of three testing personnel listed on the CMS-209. Findings are: 1. No proof of education documentation for testing personnel #3, as listed on the CMS-209, performing moderate complexity testing was presented at time of survey. 2. Interview on 9/27/2023 at 11:41 AM with the laboratory manager confirmed no documentation was available. -- 2 of 2 --

Summary Statement of Deficiencies D6031 LABORATORY DIRECTOR RESPONSIBILITIES CFR(s): 493.1407(e)(13) The laboratory director is responsible for the overall operation and administration of the laboratory, including the employment of personnel who are competent to perform test procedures, and record and report test results promptly, accurate, and proficiently and for assuring compliance with the applicable regulations. (e) The laboratory director must-- (e)(13) Ensure that an approved procedure manual is available to all personnel responsible for any aspect of the testing process; This STANDARD is not met as evidenced by: Based on lack of approved procedure manual and interview with technical consultant the laboratory director failed to have an approved procedure manual available to personnel. Findings are: 1. No approved procedure manual was available on day of survey. 2. Interview with technical consultant on 11/19/2019 at 11:30 AM confirmed no approved procedure manual was available to personnel. Statement of Deficiencies (X1) Provider/Supplier/CLIA Identification Number (X3) Date Survey Completed Name of Provider or Supplier Street Address, City, State -- 1 of 1 --